Intel and Micron (IMFT) Announce World's First 128Gb 20nm MLC NANDby Anand Lal Shimpi on December 6, 2011 12:17 PM EST
Earlier this year, Intel and Micron's joint NAND manufacturing venture (IMFT) announced it had produced 64Gb (8GB) MLC NAND on a 20nm process. Most IMFT NAND that's used in SSDs are built using a 25nm process - the move to 20nm reduces die size and in turn reduces cost over time. A single 8GB 2-bit-per-cell MLC NAND die built on IMFT's 25nm process measures in at 167mm2, while the same capacity on IMFT's 20nm process is 118mm2. Early on in any new process wafers are more expensive, but over time NAND costs should go down as they are more a function of die size than process technology.
Today Intel and Micron are both announcing a second generation 20nm part at a 128Gb (16GB capacity). This isn't just a capacity increase as the 128Gb 20nm MLC NAND features an ONFi 3 interface rather than ONFI 2.x used in the earlier 64Gb announcement and older 25nm parts. ONFI 3 increases interface bandwidth from a max of 200MT/s (IMFT 25nm was limited to 166MT/s) to 333MT/s. This has a direct impact on sequential read performance for example, as most of those operations tend to be interface bound. Note that when I'm talking about interface speed I'm referring to the maximum speed allowed between the SSD controller and the NAND itself (e.g. an 8-channel ONFI 3 controller would have 8 x 333MT/s interfaces to NAND).
Alongside the faster interface speed is yet another increase in page size. The move to 25nm NAND brought about 8KB pages (up from 4KB), the 128Gb 20nm MLC NAND solution uses 16KB pages. Because of the changes to the interface speed and page size we won't see drives/controllers use the 128Gb devices for another 1 - 1.5 years. The reason for the delay in incorporating this NAND into SSDs is two fold: 1) A 128Gb 20nm die will be pretty big (2x the size of a 64Gb die), and it'll take time for yields to improve to the point where it's cost effective, and 2) a larger page size and new interface both require a revision to the controller & firmware. Intel and Micron have both confirmed that they will not be using the 128Gb parts in SSDs until 2013.
The 128Gb 20nm parts will go into mass production in Q2 2012, giving IMFT ample time to ramp up production and work on yields before more functional deployment inside SSDs. SSD makers (and other consumers of NAND) will be able to get octal die packages using 128Gb NAND, meaning a single package can feature up to 128GB of NAND. This also paves the way for 1TB SSDs with only eight chips, or 2TB SSDs with both sides of a 2.5" PCB populated. The new Ultrabook/MacBook Air gumstick SSD form factor will be able to accommodate 512GB - 1TB of NAND using these 128Gb ODP devices.
While 128Gb parts are still some distance away, 64Gb 20nm NAND from IMFT is in mass production today. Again, don't expect to see the 64Gb parts in use in SSDs until the middle of 2012 however. Controller vendors need time to ensure support for the NAND and validate/cross-their-fingers-and-hope-it-works with their designs. IMFT also needs time to build up inventory and ensure good yields. Remember the 64Gb parts retain the ONFI 2.x support and 8KB page size of IMFT's 25nm NAND.
The big question is endurance, however we won't see a reduction in write cycles this time around. IMFT's 20nm client-grade compute NAND (used in consumer SSDs) is designed for 3K - 5K write cycles, identical to its 25nm process. IMFT have moved to a new cell architecture with a much thinner floating gate. The 20nm process is also a high-K + metal gate design, both of which contribute to maintaining endurance ratings while shrinking overall transistor dimensions.
SSDs have fallen in prices tremendously over the past few years. We're finally approaching $1/GB in many cases. With 20nm NAND due out next year, I'd say we're probably within a year of dropping below $1/GB.
Post Your CommentPlease log in or sign up to comment.
View All Comments
cynic783 - Tuesday, December 6, 2011 - linkssd's don't offer substantial improvement in performance over hdd, especially if you RAID-0 your hdd's, plus $/GB is so much lower
plus, ssd's from intel and others have huge quality problems
JarredWalton - Tuesday, December 6, 2011 - linkWhile price/GB is definitely higher, your assertion that SSDs don't offer a substantial improvement over RAID 0 HDDs is completely untrue. Boot up Windows on however many RAID 0 HDDs you want (four, or maybe even eight?), and then try launching Firefox, Thunderbird, Word, Excel, and Photoshop at the same time. You will completely bog down the system for a good chunk of time, whereas with a single good SSD they'll launch almost as fast as if nothing else was going on.
cynic783 - Tuesday, December 6, 2011 - linksorry, I have to admit I was doing a parody of the typical uninformed ssd basher; totally agree, I run SSD's exclusively
JarredWalton - Tuesday, December 6, 2011 - linkLOL... if that was a parody then you got me! I'm still waiting for the price of 512GB SSDs to get down to $250 or less. Yeah, I know, it's a long ways off. Still, unless we get some serious creep in terms of game install sizes, 512GB lets me have all my data and games on a single drive. Right now, I have to live with a 120GB SSD for the OS and apps, and my images, movies, and games are all on a 1TB HDD.
Which reminds me, I need to give some of these caching programs a try. I think I have a trial of Diskeeper's utility around somewhere, though I don't really want to reformat just to make use of it.
Kristian Vättö - Tuesday, December 6, 2011 - linkTLC NAND should cost around $0.60/GB according to OCZ, so we may finally see some sub-1$/GB 512GB SSDs early next year. I have a long article about all this in the admin engine but I haven't had time finish it up. Damn you Intel and Ivy Bridge, LOL.
Guspaz - Thursday, December 8, 2011 - linkAh, but sometimes we do see those prices during the big sales. So getting a 512GB SSD for under $250 might well be possible within two or three years if you can hit the right sale (Black Friday or Boxing Day, for example).
jwcalla - Tuesday, December 6, 2011 - linknicely done. i too was deceived by your tomfooleryishness.
you must have an amazing poker face.
Zink - Tuesday, December 6, 2011 - linkahahahaha lolololol funny funny
There's no one bashing SSDs here any more but you.
Tetracycloide - Tuesday, December 6, 2011 - linkI have little sympathy for those that didn't pick up on this after the obvious 'Intel... quality problems' jab.
Denithor - Tuesday, December 6, 2011 - linkActually...they just fixed the '8MB' error on the 320 series SSDs like 2-3 months ago.
First thing I did upon receiving my 320 120GB drive last week was to check to make sure it was running the latest firmware so I wouldn't have to worry about finding my drive suddenly reduced dramatically in capacity...